TM 9-6695-282-34P
(2) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of its engineerig
drawings specifications, at standards and inspection requirements to identify an item or range of items.
(3) STOCK NUMBER column. This column lists the NSN for the associated part number and manufacturer
identified in the PART NUMBER and FSCM columns to the left. The part number line entry (with NSN, when available)
identifies the first figure/item number appearance for which the part number is applicable. The part number is not listed for
additional figure/item number appearances identified by that part number.
(4) FIGURE column. This column lists the number of the figure where the item is located in Section II.
(5) ITEM column. The item number is that number assigned to the item as it appears in the figure referenced
in the adjacent figure number column.
c. FIGURE AND ITEM NUMBER INDEX
(1) FIGURE column. This column lists the number of the figure where the item is identified/located in Section II
.
(2) ITEM column. The item number is that number assigned to the item as it appears in the figure referenced
in the adjacent figure number column.
(3) STOCK NUMBER column. This column lists the NSN for the item.
(4) FSCM column. The Federal Supply Code for Manufacturer (FSCM) is a 5-digit numeric code used to
identify the manufacturer, distributor, or Government agency, etc., that supplies the item.
(5) PART NUMBER column. Indicates the primary number used by the manufacturer (individual, firm,
corporation, or Government activity), which controls the design and characteristics of the item by means of its engineering
drawings, specifications, standards, and inspection requirements to identify an item or range of items.
5. Special Information
a. Repair parts for components of standards sets which can be identified as existing in the supply system will be
requisitioned through normal supply channels from the appropriate supply commodity manager.
b. Repair parts for components of standards sets which cannot be identified as to proper supply source will be
requisitioned from USAMICOM, using routing identifier B64 and furnishing, as a minimum, the following as exception data:
(1) Component stock number of the individual end item to be repaired.
(2) Component manufacturer's equipment model number and serial number.
4
Previous Page
