INTRODUCTION
Explanation
Code
1-1. Scope
P E - Support equipment procured and stocked for
This manual lists repair parts and special tools
initial issue or outfitting to specified main-
required for the performance of organizational
tenance repair activities.
maintenance of the TS-186D/UP. The PCCN for the
P F - Support equipment which will not be stocked
TS-186D/UP is GTEAFM for all models.
but which will be centrally procured on
demand.
1-2. General
P G - Item procured and stocked to provide for
This repair parts and special tools list is divided into
sustained support for the life of the
the following sections:
equipment. It is applied to an item
a. Prescribed Load Allowance (PLA) - Section II.
peculiar to the equipment which because
Not applicable.
of probable discontinuance or shutdown of
production facilities would prove un-
parts authorized for the performance of mainte-
economical to reproduce at a later time.
nance at the organizational level. This repair parts
KD - An item of depot overhaul/repair kit and not
list is arranged in alphabetical order.
purchased separately. Depot kit defined
c. Special Tools, Test and Support Equip-
as a kit that provides items required at the
ment -Section IV. Not applicable.
time of overhaul or repair.
d. Index - Federal Stock Number and Reference
K F - An item of a maintenance kit and not
Number Cross-Reference to Figure and Item
purchased separately. Maintenance kit
Number - Section V. A list, in ascending numerical
defined as a kit that provides an item that
sequence, of all Federal stock numbers appearing in
can be replaced at organizational or direct
the listings, followed by a list, in alphanumeric
support or general support levels of
sequence, of all reference numbers appearing in the
maintenance.
listings. Federal stock number and reference num-
KB - I t e m included in both a depot over-
bers are cross-referenced to each illustration figure
haul/repair kit and a maintenance kit.
and item number or reference designation appear-
MO - Item to be manufactured or fabricated at
ance.
organizational level.
MF - Item to be manufactured or fabricated at
direct support maintenance level.
The following provides an explanation of columns in
MH - Item to be manufactured or fabricated a t
the tabular lists:
general support maintenance level.
a. Source, Maintenance, and Recoverability Codes
MD - Item to be manufactured or fabricated at
(SMR).
depot maintenance level.
(1) Source code. Indicates the manner of acquir-
AO - Item to be assembled at organizational level.
ing support items for maintenance, repair, or
A F - Item to be assembled at direct support
overhaul of end items. Source codes are:
maintenance level.
Code
Explanation
AH - Item to be assembled at general support
PA - Item procured and stocked for anticipated or
maintenance level.
known usage.
AD - Item to be assembled at depot maintenance
P B - Item procured and stocked for insurance
level.
purposes because essentiality dictates
X A - Item is not procured or stocked because the
that a minimum quantity be available in
requirements for the item will result in
the supply systems.
the replacement of the next higher as-
P C - Item procured and stocked and which
sembly.
otherwise would be coded PA except that
X B - Item is not procured or stocked. If not
it is deteriorative in nature.
available through salvage, requisition.
PD - Support item, excluding support equipment,
XC - Installation drawing, diagram instruction
procured for initial issue or outfitting and
sheet, field service drawing, that is iden-
stocked only for subsequent or additional
tified by manufacturers' part number.
initial issues or outfitting. Not subject to
XD - Support items can be requisitioned with
automatic replenishment.
Previous Page
