INTRODUCTION
stocked only for subsequent or additional
initial issues or outfitting. Not subject to
This manual lists repair parts and special tools
automatic replenishment.
required for the performance of direct support,
PE -
Support equipment procured and stocked for
general support, and depot maintenance of the
initial issue or outfitting to specified main-
TS-186D/UP. The PCCN for the TS-186D/UP is
tenance repair activities.
GTEAFM for all models.
PF -
Support equipment which will not be stocked
1-2. General
but which will be centrally procured on
This repair parts and special tools list is divided into
demand.
Item procured and stocked to provide for
the following sections:
PG -
sustained support for the life of the
parts authorized for the performance of mainte-
equipment. It is applied to an item
nance at the direct support, general support, and
peculiar to the equipment which because
depot level. This repair parts list is arranged in
of probable discontinuance or shutdown of
alphabetical order.
production facilities would prove un-
b. Special Tools, Test and Support Equipment-
economical to reproduce at a later time.
KD -
An item of depot overhaul/repair kit and not
equipment authorized for the performance of
purchased separately. Depot kit defined
maintenance at the direct support, general support
as a kit that provides items required at the
and depot level.
time of overhaul or repair.
c. Index - Federal Stock Number and Reference
An item of a maintenance kit and n o t
KF -
Number Cross - Reference to Figure and Item
purchased separately. Maintenance kit
Number - Section IV. A list, in ascending numerical.
defined as a kit that provides an item that
sequence, of all Federal stock numbers appearing in
can be replaced at organizational or direct
Support or general support levels of
the listings, followed by a list, in alphanumeric
sequence, of all reference numbers appearing in the
maintenance.
Item included in both a depot over-
listings. Federal stock number and reference num-
KB -
haul/repair kit and a maintenance kit.
bers are cross-referenced to each illustration figure
and item number or reference designation appear-
Item to be manufactured or fabricated at
MO -
ance.
organizational level.
MF -
Item to be manufactured or fabricated at
direct support maintenance level.
The following provides an explanation of columns
Item to be manufactured or fabricated at
MH -
found in the tabular list.
general support maintenance level.
a. Source, Maintenance, and Recoverability Codes
Item to be manufactured or fabricated at
MD -
(SMR).
depot maintenance level.
(1) Source code. Indicates the manner of acquir-
Item to be assembled at organizational level.
AO -
ing support items for maintenance, repair, or
Item to be assembled at direct support
AF -
overhaul of end items. Source codes are:
maintenance level.
Item to be assembled at general support
AH -
maintenance level.
PA - Item procured and stocked for anticipated or
Item to be assembled at depot maintenance
AD -
known usage.
level.
PB - Item procured and stocked for insurance
XA -
Item is not procurred or stocked because the
purposes because essentiality dictates
requirements for the item will result in
that a minimum quantity be available in
the replacement of the next higher as-
the supply systems.
sembly.
XB -
PC - Item procured and stocked and which
Item is not procured or stocked. If not
available through salvage, requisition.
otherwise would be coded PA except that
-
XC
Installation drawing, diagram instruction
it is deteriorative in nature.
sheet, field service drawing, that is iden-
P D - Support item, excluding support equipment,
tified by manufacturers' part number.
procured for initial issue or outfitting and
Previous Page
