TM 11-6625-486-14&P
Table 6-13. Audio Power Output With Internal Crystal Oscillator Test-Continued
Control Settings
Step
No. Test Equipment
Test Procedure
Performance Standard
Equipment under test
11
Same as step No. 1.
Same as step No.
1, Same as steps No. 1, 2, and 3.
Same as step No. 2.
except: TUNING:
65.00. RANGE: C.
12
Same as step No. 1.
Same as step No.
11, Same as steps No. 1, 2, and 3.
Same as step No. 2.
except: TUNING:
85.00.
13
Same as step No. 1.
Same as step No.
11, Same as steps No. 1, 2, and 3.
Same as step No. 2.
except: TUNING:
110.00.
14
Same as step No. 1.
Same as step No.
11, Same as steps, No. 1, 2, and 3.
Same as step No. 2.
except: TUNING:
130.00.
(6) 600-ohm dummy load.
6-41. Audio Power Output With External Rf Input
Signal Test
b. Test Connections and Conditions . Set up the
a. Test Equipment and Materials.
equipment as shown in figure 6-23. Do not connect the
AN/USM-151(*), except the 600-ohm dummy load, or
(1) Oscilloscope AN/USM-151(*).
the rf signal generators until indicated.
(2) Rf Signal Generator Set AN/URM-25F.
Follow the procedures given in
c. Procedures.
(3) Rf Signal Generator AN/URM-44A.
(4) Rf Signal Generator AN/URM-49(*).
(5) Multimeter TS-352B/U.
6-44
Previous Page
