TM 11-6625-486-14&P
specifies, by the listing of a "worktime" figure in the
appropriate subolumn(s), the lowest level of
e. Column 5, Tools and Equipment. Column 5
maintenance authorized to perform the function listed in
specifies by code, those common tool sets (not
column 3. This figure represents the active time
individual tools) and special tools, test, and support
required to perform that maintenance function at the
equipment required to perform the designated function.
indicated category of maintenance. If the number or
C-4. Tool and Test Equipment Requirements (Table
complexity of the tasks within the listed maintenance
function vary at different maintenance categories,
a. Tool or Test Equipment Reference Code. The
appropriate "worktime" figures will be shown for each
numbers in this column coincide with the numbers used
category. The number of man-hours specified by the
in the tools and equipment column of the MAC. The
"worktime" figure represents the average time required
numbers indicate the applicable tool or test equipment
to restore an item (assembly, subassembly, component,
for the maintenance functions.
module, end item or system) to a serviceable condition
b. Maintenance Category.
The codes in this
under typical field operating conditions. This time
column indicate the maintenance category allocated the
includes preparation time, troubleshooting time and
tool or test equipment.
quality assurance/quality control time in additional to the
c. Nomenclature. This column lists the noun name
time required to perform the specific tasks identified for
and nomenclature of the tools and test equipment
the maintenance functions authorized in the
required to perform the maintenance functions.
maintenance allocation chart. Subcolumns of column 4
d. National/NATO Stock Number. This column
are as follows:
lists the National/NATO stock number of the specific
C - Operator/Crew
tool or test equipment.
O - Organizational
F - Direct Support
e. Tool Number.
This column lists the
H - General Support
manufacturer's part number of the tool followed by the
D - Depot
Federal Supply Code for manufacturers (5-digit) in
parentheses.
C-2
Previous Page
