TM 11-6625-3087-12
4. If an OFFSET is required,
Press OFFSET (12).
Enter offset value ( 10).
Press MEAS CONT (7).
Press OFFSET (6).
NOTE
Do not change the units after offset has been entered.
5. MEASUREMENT/ENTRY display (4) indicates input signal power level.
NOTE
Input signal modulation (AM or FM) may cause instability in MEASUREMENT/EN-
TRY display.
6.
If MEASUREMENT/ENTRY display is unstable or constantly resets full scale level,
Press AVE (2). If display still unstable, turn AVE off.
Press ENTRY (1).
Press FULL SCALE (13), UP ARROW (9) or DOWN ARROW (8) then MEAS CONT (7) push buttons until
display is stable. Verify OVLD indicator (3) remains off.
NOTE
If OVLD indicator is on or "OL" appears in MEASUREMENT/ENTRY display, increase
full scale level. If "UL" appears in MEASUREMENT/ENTRY display, decrease full
scale level.
2-27
Previous Page
